Zibro S1135 Specifications download pdf (Page 20)

H PROBLEM SOLVING

The following problems do not always indicate a fault. Please check them before contacting the service

department:

Problem Cause / Solution

he plug is not inserted firmly in the socket.

he batteries in the remote control are empty.

The safety feature has been activated or the fuse has burnt out.

Are the air inlets or outlets blocked?

s the temperature set correctly?

Is the screen filter dirty?

No effective operation.

Faults (due to static electricity discharges or disruptions in the

power supply) will prevent the machine from operating correctly.

If this is the case, pull the plug out of the socket, and then re-

insert it after 2-3 seconds.

Does not start immediately. Changing the mode during operation: 3 minute delay.

Unusual odour.

Odour may be caused by another source – furniture, cigarettes,

etc. The unit expels air that it has sucked in.

Caused by the refrigerant in the air conditioner: this does not

indicate a fault.

The sound of defrosting in the heating mode.

A creaking sound.

The sound may be caused by the expansion/shrinkage of the

front panel as a consequence of temperature fluctuations.

Mist/moisture is expelled from the air outlet.

Condensation/mist is created when the air temperature in the

room drops significantly due to the fact that cold air is expelled

in the COOLING or DRY mode.

The red compressor indicator flashes

constantly and the fan in the indoor unit

ceases to operate.

The unit will switch from the heating mode to the defrosting

mode. The indicator light will go out within 10 minutes and the

unit will return to the heating mode.

No cooled or heated air.

The sound of running water.

The unit does not operate.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 81 82

No comments

Zibro S1135 Specifications Page 20