Zibro Kamin SRE 187 Specifications download pdf (Page 47)

☞

Check the removable tank fuel gauge  while filling the tank (Fig. E). Stop

filling by loosening the switch button on top of the pump (turn anti-clock-

wise), once the gauge indicates that the tank is full. Never overfill the tank,

especially not when the fuel is very cold (fuel expands when it heats up).

Let the remaining fuel in the pump flow back into the jerrycan and carefully

remove the pump. Carefully screw the fuel cap back on the tank using the

fuel cap cover. After use, re-store the cover at the rear of the heater. Clean

off any spilled fuel.

Check whether the fuel cap is straight and tightened properly. Reinstall the

removable tank in the heater (cap down). Close the lid.

C SETTING THE CLOCK

It is only possible to set the correct time, when the heater is connected to the

mains and not burning. Use the adjustment keys

 to set the time. First press

either of the two keys to switch on the function (the CLOCK light and the

information display

 will start blinking). Next, set the hours using the key on the

left (

hour) and the minutes using the key on the right (min.). Press once to

increase the value by one step. When you hold down the key, the value will

continue going up, until you release the key again. After approximately 10

seconds the blinking will stop and the setting will be locked. 5 minutes after

switching off the heater, the information on the display will disappear and the

heater will automatically switch into the stand-by position.

When the heater has been unplugged for more than 10 minutes (or after a

power failure), the time needs to be set again.

D IGNITING THE HEATER

When used for the first time, a new heater may give out a smell for a short while.

You should therefore provide extra ventilation. Always ignite the heater with the

button 

. Never use matches or a cigarette lighter.

Just press the button  to ignite the heater. The button will start blinking,

indicating that the ignition procedure has started. This will take a short while. Once

the heater is burning, the button

 will remain lit (red). The information display

 will show two numbers. The light next to them indicates that these numbers

refer to the temperatures (Fig. G). The actual room temperature is indicated below

ROOM, while the temperature setting is indicated below SET. The latter can be

changed with the adjustment keys

(refer to Section E).

Prior to igniting the heater, always check for sufficient fuel in the removable tank.

E SETTING THE REQUIRED TEMPERATURE

The temperature setting can only be adjusted, when the heater is burning. Use the

adjustment keys

 to adjust the temperature. First press either of the two keys to

switch on the function (the TEMP light next to the information display

 will start

blinking). Next, adjust the temperature using the key on the right (

min.) to set

the temperature to a higher setting and the key on the left (

hour) to lower the

temperature. Press once to increase the value one step. After approximately 10

seconds the light will stop blinking and the setting will be locked (Fig. G).

SRE 187

empty full

19:14

set room

temp.

clock

G: The required

temperature on the left,

the measured

temperature on the

right.

set

temp.

clock

F: When the CLOCK

indicator light stops

blinking, the setting has

been locked to the

indicated value.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 73 74

Comments to this Manuals

No comments

Zibro Kamin SRE 187 Specifications Page 47

Comments to this Manuals

Related products and manuals for Space heaters Zibro Kamin SRE 187