Zibro SRE 130 TC Specifications download pdf (Page 9)

☞

ithout the 'SAVE' setting your heater will maintain the set temperature by

approximation as well, by adjusting its heating capacity. 'SAVE' is an economy

setting, which you can use when, for instance, you are not present in the room

or to keep it frost-free.

K THE 'FUEL' INDICATOR

When the FUEL indicator appears, there is enough fuel left for another 10 minutes

of heater use. The count-down of the remaining heating time can be seen in the

information display

M (Fig. J). Every two minutes an alarm signal is sounded,

warning you to refill the removable tank. If you do not react, the heater will

extinguish by itself. The heater will also sound a warning signal, when it switches

off. The FUEL indicator will blink, while four lines are blinking in the information

display. You can stop this by pressing the button

N once.

Once the heater has used up all its fuel and is extinguished it will take some time,

after the refill, before the heater is completely ready for use again.

L THE 'VENT' INDICATOR

When the VENT indicator starts blinking, this is a sign that the room is not vented

sufficiently (Fig. K). The heater will switch off automatically. If the indicator

continues blinking after extra ventilation, please contact your dealer.

M MAINTENANCE

Switch off the heater and let it cool down, before you start any maintenance

work. Also disconnect the plug from the mains. Your heater needs hardly any

maintenance. It is, however, important that you clean the air filter

I and the vent

filter

J with a vacuum cleaner and the grid 2 with a damp cloth, both on a

weekly basis. Remove the air filter occasionally (Fig. L) and clean it with soapy

water. Prior to reinstallation, make sure that the air filter cap has fully been dried.

Regularly inspect the fuel filter as well:

Remove the removable tank

7 from the heater and remove the fuel filter

(Fig. M). Some drops may leak from the filter; keep a cloth at hand.

Remove the dirt by tapping the fuel filter upside-down against a hard surface.

(Never clean it with water!)

Reinstall the fuel filter into the heater.

e recommend that you remove dust and stains from time to time with a damp

cloth, because otherwise these may cause stains that are hard to remove.

Do not r

emove any heater components yourself. Always contact your dealer for

repairs. When the power cord is damaged, it may only be replaced by an

authorised fitter. Use a new cord of the type H05 VV-F.

Fuel filter

K: A blinking VENT

indicator is a sign that

you need extra

ventilation.

: When the FUEL

indicator has appeard,

the information display

will show the number of

minutes of fuel left in

the tank.

☞

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Zibro SRE 130 TC Specifications Page 9

Comments to this Manuals

Related products and manuals for Space heaters Zibro SRE 130 TC